Matrix-orbital LK162-12 Legacy Instrukcja Użytkownika Pobierz pdf (Strona 7)

LK162-12 rev 4

1.7 Manual Override

Manual override should only be required in one instance. If for some reason the module is set at a baud rate

which cannot be produced by the host system and all communication to the display is lost, then the user

should follow this simple procedure:

1. Turn off the display

2. Put a jumper on pins 3 and 4 of the keypad connector (R3 and C1).

3. Power up the display. The baud rate is now set to 19,200.

4. Remove the jumper and change the RS-232 port settings to the desired baud rate.

5. Turn off the display.

6. Power up the display.

Refer to the “Set RS-232 Port Speed” command (section 6.1.11) for acceptable baud rates.

Place jumper on the above pins

1 2 3 4 5 6 7 8 9 10 11 12 ... 36 37

Brak uwag

Matrix-orbital LK162-12 Legacy Instrukcja Użytkownika Strona 7